ASTM E1016-07(2020) PDF

Scope: 1.1 The purpose of this guide is to familiarize the analyst with some of the relevant literature describing the physical properties of modern electrostatic electron spectrometers. 1.2 This guide is intended to apply to electron spectrometers generally used in Auger electron spectroscopy (AES) and X-ray photoelectron spectroscopy (XPS). 1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E1016-07(2020) Referenced Document

ASTM E1217 Standard Practice for Determination of the Specimen Area Contributing to the Detected Signal in Auger Electron Spectrometers and Some X-Ray Photoelectron Spectrometers
ASTM E2108 Standard Practice for Calibration of the Electron Binding-Energy Scale of an X-Ray Photoelectron Spectrometer
ASTM E673 Standard Terminology Relating to Surface Analysis
ASTM E902 Standard Practice for Checking the Operating Characteristics of X-Ray Photoelectron Spectrometers
ISO 18516 Surface chemical analysis — Determination of lateral resolution and sharpness in beam based methods with a range from nanometres to micrometres
ISO 21270 Surface chemical analysis - X-ray photoelectron and Auger electron spectrometers - Linearity of intensity scale
ISO 24236 Surface chemical analysis - Auger electron spectroscopy - Repeatability and constancy of intensity scale
ISO 24237 Surface chemical analysis - X-ray photoelectron spectroscopy - Repeatability and constancy of intensity scale

2020 ASTM E1016-07(2020) Standard Guide for Literature Describing Properties of Electrostatic Electron Spectrometers
2007 ASTM E1016-07(2012)e1 Standard Guide for Literature Describing Properties of Electrostatic Electron Spectrometers
2007 ASTM E1016-07 Standard Guide for Literature Describing Properties of Electrostatic Electron Spectrometers
1996 ASTM E1016-96(2002) Standard Guide for Literature Describing Properties of Electrostatic Electron Spectrometers
1996 ASTM E1016-96 Standard Guide for Literature Describing Properties of Electrostatic Electron Spectrometers