ASTM A775/A775M-17
Standard Specification for Epoxy-Coated Steel Reinforcing Bars

Standard No.
ASTM A775/A775M-17
Release Date
2017
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM A775/A775M-19
Latest
ASTM A775/A775M-22
Scope

1.1 This specification covers deformed and plain steel reinforcing bars with protective epoxy coating applied by the electrostatic spray method.

Note 1: The coating applicator is identified throughout this specification as the manufacturer.

1.2 Other organic coatings may be used provided they meet the requirements of this specification.

1.3 Requirements for coatings are contained in Annex A1.

1.4 Requirements for patching material are contained in Annex A2.

1.5 Guidelines for construction practices at the job-site are presented in Appendix X1.

1.6 This specification is applicable for orders in either SI units (as Specification A775M) or inch-pound units [as Specification A775].

1.7 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM A775/A775M-17 Referenced Document

  • ASTM A615/A615M Standard Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement
  • ASTM A706/A706M Standard Specification for Deformed and Plain Low-Alloy Steel Bars for Concrete Reinforcement
  • ASTM A944 Standard Test Method for Comparing Bond Strength of Steel Reinforcing Bars to Concrete Using Beam-End Specimens
  • ASTM A996/A996M Standard Specification for Rail-Steel and Axle-Steel Deformed Bars for Concrete Reinforcement
  • ASTM B117 Standard Practice for Operating Salt Spray (Fog) Apparatus
  • ASTM D2967 Standard Test Method for Edge Coverage of Coating Powders
  • ASTM D374 Standard Test Methods for Thickness of Solid Electrical Insulation
  • ASTM D4060 Standard Test Method for Abrasion Resistance of Organic Coatings by the Taber Abraser
  • ASTM G14 Standard Test Method for Impact Resistance of Pipeline Coatings (Falling Weight Test)
  • ASTM G20 Standard Test Method for Chemical Resistance of Pipeline Coatings
  • ASTM G62 Standard Test Methods for Holiday Detection in Pipeline Coatings
  • ASTM G8 Standard Test Methods for Cathodic Disbonding of Pipeline Coatings

ASTM A775/A775M-17 history

Standard Specification for Epoxy-Coated Steel Reinforcing Bars


Copyright ©2024 All Rights Reserved