This European Standard specifies a method for determining the consistency of bitumen and bituminous binders. Normal procedure is described for penetrations up to (330 × 0,1) mm, but for penetrations above this value, up to (500 × 0,1) mm, different operating parameters are necessary. WARNING - Use of this European Standard may involve hazardous materials, operations and equipment. This European Standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this European Standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
EN 1426:2015 Referenced Document
EN 10088-3:2014 Stainless steels - Part 3: Technical delivery conditions for semifinished products@ bars@ rods@ wire@ sections and bright products of corrosion resisting steels for general purposes
EN 12594:2014 Bitumen and bituminous binders - Preparation of test samples
EN 12597:2014 Bitumen and bituminous binders - Terminology
EN 1427:2015 Bitumen and bituminous binders - Determination of the softening point - Ring and Ball method
EN ISO 1101:2013 Geometrical product specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and runout
EN ISO 1302:2002 Geometrical Product Specifications (GPS) - Indication of Surface Texture in Technical Product Documentation ISO 1302: 2002
EN ISO 286-1:2010 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 1: Basis of tolerances, deviations and fits (ISO 286-1:2010)
EN ISO 6508-1:2015 Metallic materials - Rockwell hardness test - Part 1: Test method (ISO 6508-1:2015)
EN 1426:2015 history
2015EN 1426:2015 Bitumen and bituminous binders - Determination of needle penetration