ISO 19272:2015 PDF

Scope: This International Standard specifies a glow discharge optical emission spectrometric (GD-OES) method for determination of the mass fraction Carbon, Silicon, Manganese, Phosphorus, Sulfur, Chromium, Nickel, Aluminium, Titanium and Copper in low alloyed steels. The content ranges to which the method is applicable are shown in Table 1. Table 1 — Content ranges Element Content ranges mass fraction % C 0,060 to 0,35 Si 0,14 to 1,50 Mn 0,090 to 0,70 P 0,010to 0,070 S 0,005 to 0,050 Cr 0,008 to 0,65 Ni 0,050 to 0,50 Al 0,006 to 0,90 Ti 0,014 to 0,13 Cu 0,005 to 1,00

ISO 19272:2015 Referenced Document

ISO 14284:1996 Steel and iron - Sampling and preparation of samples for the determination of chemical composition
ISO 14707:2015 Surface chemical analysis - Glow discharge optical emission spectrometry (GD-OES) - Introduction to use
ISO 16962:2005 Surface chemical analysis - Analysis of zinc- and/or aluminium-based metallic coatings by glow-discharge optical-emission spectrometry
ISO 5725-1:1994 Accuracy (trueness and precision) of measurement methods and results - Part 1: General principles and definitions
ISO 5725-2:1994 Accuracy (trueness and precision) of measurement methods and results - Part 2: Basic method for the determination of repeatability and reproducibility of a standard measurement method
ISO 5725-3:1994 Accuracy (trueness and precision) of measurement methods and results - Part 3: Intermediate measures of the precision of a standard measurement method

2015 ISO 19272:2015 Low alloyed steel - Determination of C, Si, Mn, P, S, Cr, Ni, Al, Ti and Cu - Glow discharge optical emission spectrometry (routine method)