ISO 48-9:2018
Rubber, vulcanized or thermoplastic - Determination of hardness - Part 9: Calibration and verification of hardness testers

Standard No.
ISO 48-9:2018
Release Date
2018
Published By
International Organization for Standardization (ISO)
Latest
ISO 48-9:2018
Scope
This document specifies procedures for the calibration and verification of durometers of types A, D, AO and AM (see ISO 48-4), IRHD pocket meters (see ISO 48-5), IRHD dead-load instruments (see ISO 48-2) and dead-load instruments using the very low rubber hardness scale (see ISO 48-3).

ISO 48-9:2018 Referenced Document

  • ISO 18899:2013 Rubber - Guide to the calibration of test equipment
  • ISO 48-2:2018 Rubber, vulcanized or thermoplastic - Determination of hardness - Part 2: Hardness between 10 IRHD and 100 IRHD
  • ISO 48-3:2018 Rubber, vulcanized or thermoplastic - Determination of hardness - Part 3: Dead-load hardness using the very low rubber hardness (VLRH) scale
  • ISO 48-4:2018 Rubber, vulcanized or thermoplastic - Determination of hardness - Part 4: Indentation hardness by durometer method (Shore hardness)
  • ISO 48-5:2018 Rubber, vulcanized or thermoplastic - Determination of hardness - Part 5: Indentation hardness by IRHD pocket meter method
  • ISO/IEC 17025:2017 General requirements for the competence of testing and calibration laboratories

ISO 48-9:2018 history

  • 2018 ISO 48-9:2018 Rubber, vulcanized or thermoplastic - Determination of hardness - Part 9: Calibration and verification of hardness testers
Rubber, vulcanized or thermoplastic - Determination of hardness - Part 9: Calibration and verification of hardness testers



Copyright ©2024 All Rights Reserved