ISO 11298-1:2018 PDF

Scope: This document specifies the requirements and test methods for plastics piping systems intended to be used for the renovation of underground water supply networks. It is applicable to pipes and fittings, as manufactured, as well as to the installed lining system. It is not applicable to the existing pipeline or any non-structural sprayed coatings or annular filler. This document gives the general requirements common to all relevant renovation techniques.

ISO 11298-1:2018 Referenced Document

EN 681-1:1996 Elastomeric Seals - Material Requirements for Pipe Joint Seals Used in Water and Drainage Applications - Part 1: Vulcanized Rubber (Incorporates Amendment A1: 1998)
EN 681-2:2000 Elastomeric seals - Materials requirements for pipe joint seals used in water and drainage applications - Part 2: Thermoplastic elastomers
EN 681-3:2000 Elastomeric Seals - Materials Requirements for Pipe Joint Seals Used in Water and Drainage Applications - Part 3: Cellular Materials of Vulcanized Rubber Incorporates Amendment A1: 2002; Incorporates Amendment A2: 2005
EN 681-4:2000 Elastomeric seals - Materials requirements for pipe joint seals used in water and drainage applications - Part 4: Cast polyurethane sealing elements
ISO 11295:2017 Classification and information on design and applications of plastics piping systems used for renovation and replacement
ISO 11298-3:2010 Plastics piping systems for renovation of underground water supply networks - Part 3: Lining with close-fit pipes
ISO 4427-1:2007 Plastics piping systems - Polyethylene (PE) pipes and fittings for water supply - Part 1: General
ISO 4633:2015 Rubber seals - Joint rings for water supply, drainage and sewerage pipelines - Specification for materials

2018 ISO 11298-1:2018 Plastics piping systems for renovation of underground water supply networks - Part 1: General
2010 ISO 11298-1:2010 Plastics piping systems for renovation of underground water supply networks - Part 1: General