EN 16136:2015
Automotive fuels - Determination of manganese and iron content in unleaded petrol - Inductively coupled plasma optical emission spectrometry (ICP OES) method

Standard No.
EN 16136:2015
Release Date
2015
Published By
European Committee for Standardization (CEN)
Latest
EN 16136:2015
Replace
FprEN 16136-2014
Scope
This European Standard specifies a method based on inductively coupled plasma optical emission spectrometry (ICP OES) for the determination of manganese content from about 0,5 mg/l to about 7,5 mg/l and of iron content from about 1,4 mg/l to about 6,0 mg/l in unleaded petrol containing up to 3,7 % (m/m) oxygen. WARNING - The use of this European Standard may involve hazardous materials, operations and equipment. This European Standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this European Standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use. NOTE 1 Manganese as MMT and iron as ferrocene are added to petrol to increase anti-knock properties. NOTE 2 Solutions of MMT in petrol are unstable when exposed to light. Low and erratic results are expected if petrol samples are exposed to light prior the analysis. Iron and manganese contents higher than 6,0 mg/l and 7,5 mg/l respectively may be measured after preliminary dilution of the sample with a suitable solvent. However, the precision has not been established for such a procedure. Further work regarding automotive ethanol (E85) fuel is on-going in CEN. NOTE 3 For the purposes of this European Standard, the terms "% (m/m)" and "% (V/V)" are used to represent the mass fraction (µ) and the volume fraction () of a material respectively.

EN 16136:2015 Referenced Document

  • EN ISO 1042:1999 Laboratory Glassware - One-Mark Volumetric Flasks
  • EN ISO 12185:1996 Crude petroleum and petroleum products - Determination of density - Oscillating U-tube method (ISO 12185:1996)
  • EN ISO 3170:2004 Petroleum liquids - Manual sampling (ISO 3170:2004)
  • EN ISO 3171:1999 Petroleum liquids - Automatic pipeline sampling (ISO 3171:1988)
  • EN ISO 3675:1998 Crude petroleum and liquid petroleum products - Laboratory determination of density - Hydrometer method (ISO 3675:1998)

EN 16136:2015 history

  • 2015 EN 16136:2015 Automotive fuels - Determination of manganese and iron content in unleaded petrol - Inductively coupled plasma optical emission spectrometry (ICP OES) method



Copyright ©2024 All Rights Reserved