ASTM C839-82(2015) PDF

Scope: 4.1 All porcelain enamel coatings or glass coatings are by necessity under some degree of compression at room temperature. The desired degree of compression or stress depends upon the type of ware and the end use of the item. Some method of determining relative compressive stress of enamels is necessary to establish the suitability of an enamel for a proposed application.

1.1 This test method covers the measurement of the compressive stresses (Note 1) developed by fired porcelain enamels using the loaded-beam method.

Note 1: Although some may interpret the calculations that are used in this test method as indicating compressive load, it is commonly referred to as compressive stress within the porcelain enamel industry.

1.2 This test method is limited to the use of the loaded-beam method. However, this method includes charts (Fig. 1 and Fig. 2) that provide for conversion of loaded-beam test results to warp and ring stress values.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM C839-82(2015) Referenced Document

ASTM A424 Standard Specification for Steel, Sheet, for Porcelain Enameling*， 2024-04-20 Update

2020 ASTM C839-82(2020) Standard Test Method for Compressive Stress of Porcelain Enamels by Loaded-Beam Method
1982 ASTM C839-82(2015) Standard Test Method for Compressive Stress of Porcelain Enamels by Loaded-Beam Method
1982 ASTM C839-82(2010) Standard Test Method for Compressive Stress of Porcelain Enamels by Loaded-Beam Method
1982 ASTM C839-82(2005) Standard Test Method for Compressive Stress of Porcelain Enamels by Loaded-Beam Method
1982 ASTM C839-82(1999) Standard Test Method for Compressive Stress of Porcelain Enamels by Loaded-Beam Method