ASTM F147-87(2017) PDF

Scope: 4.1 This test method is designed to measure the ability of non-metallic gasket materials to withstand handling, as would be encountered before and during installation of cut gaskets.

1.1 This test method covers the determination of the flexibility of non-metallic gasket materials. It is designed for testing specimens cut from sheet goods or from the gasket in the finished form, as supplied for commercial use. Materials normally classified as rubber compounds are excluded since they are covered in Classification D2000.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM F147-87(2017) Referenced Document

ASTM D2000 Standard Classification System for Rubber Products in Automotive Applications*， 2018-06-01 Update
ASTM F104 Standard Classification System for Nonmetallic Gasket Materials*， 2020-01-01 Update
ASTM F146 Standard Test Methods for Fluid Resistance of Gasket Materials*， 1998-04-20 Update

1987 ASTM F147-87(2017) Standard Test Method for Flexibility of Non-Metallic Gasket Materials
1987 ASTM F147-87(2009) Standard Test Method for Flexibility of Non-Metallic Gasket Materials
1987 ASTM F147-87(2003) Standard Test Method for Flexibility of Non-Metallic Gasket Materials
1997 ASTM F147-87(1997) Standard Test Method for Flexibility of Non-Metallic Gasket Materials