- Standard No.
- EN ISO 26424:2016
- Release Date
- 2016
- Published By
- European Committee for Standardization (CEN)
- Latest
-
EN ISO 26424:2016
- Replace
-
FprEN ISO 26424:2015
- Scope
- This International Standard specifies a method for measuring the abrasion wear rate of ceramic coatings using a micro-abrasion test based on the well-known dome grinding method for determining coating thickness according to ISO 26423 [11]. Using this method, data can be obtained to determine the abrasion wear rates of both the coating and the base material, either through two separate tests or through careful analysis of the data obtained from a single series of tests. The test procedure can be applied to samples with flat or non-flat surfaces, while the evaluation described in Section 9 applies only to flat samples. For non-planar samples, more complex evaluation is required, possibly using numerical methods.
EN ISO 26424:2016 Referenced Document
- ASTM B611-13 Standard Test Method for Determining the High Stress Abrasion Resistance of Hard Materials*, 2024-04-20 Update
- ASTM G105-02 Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests*, 2024-04-20 Update
- ASTM G65-16 Standard Test Method for Measuring Abrasion Using the Dry Sand/Rubber Wheel Apparatus*, 2024-04-20 Update
- EN 1071-2:2002 Advanced technical ceramics - Methods of test for ceramic coatings - Part 2: Determination of coating thickness by the crater grinding method*, 2024-04-20 Update
- ISO 26423:2009 Fine ceramics (advanced ceramics, advanced technical ceramics) - Determination of coating thickness by crater-grinding method
- ISO 3290-1:2008 Rolling bearings — Balls — Part 1: Steel balls
- ISO/IEC 17025:2005 General requirements for the competence of testing and calibration laboratories
EN ISO 26424:2016 history
- 2016 EN ISO 26424:2016 Fine ceramics (advanced ceramics@ advanced technical ceramics) - Determination of the abrasion resistance of coatings by a micro-scale abrasion test
EN ISO 26424:2016 Fine ceramics (advanced ceramics@ advanced technical ceramics) - Determination of the abrasion resistance of coatings by a micro-scale abrasion test has been changed from EN 1071-6:2007 Advanced technical ceramics - Methods of test for ceramic coatings - Part 6: Determination of the abrasion resistance of coatings by a micro-abrasion wear test.