This European Standard specifies a quick method for determining, by evaporation, the water content of bituminous road emulsions, with or without polymer added. For bituminous emulsions without flux oil, bituminous emulsions containing vegetal flux oil, and bituminous emulsions containing up to 1,5 % mass of mineral flux oil in the emulsion, this European Standard, according to the selected operating conditions, is considered as an alternative method to the reference methods EN 1428 and EN 1431. Above a mineral flux oil content of 1,5 % by mass, depending on the volatility of the flux oil:- the present method can be used if the user can prove its reliability in comparison to EN 1428 or EN 1431; - the present method can only be used by correcting the result by means of a previously established correlation with the reference method EN 1428 or EN 1431. NOTE Polymer modified emulsions can behave differently in the test than unmodified emulsions; in case of doubt, the method is checked against EN 1428 or EN 1431. In case of dispute, the water content should be determined according to EN 1428 or EN 1431. WARNING - The use of this European Standard can involve hazardous materials, operations and equipment. This European Standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this European Standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
EN 16849:2016 Referenced Document
EN 12594:2014 Bitumen and bituminous binders - Preparation of test samples
ISO 5725-2:1994 Accuracy (trueness and precision) of measurement methods and results - Part 2: Basic method for the determination of repeatability and reproducibility of a standard measurement method
EN 16849:2016 history
2016EN 16849:2016 Bitumen and bituminous binders - Determination of water content in bituminous emulsions - Method using a drying balance