ASTM D3291-11(2016)e1 PDF

Scope: 5.1 It is possible for plasticizers to become less compatible in poly(vinyl chloride) resin when fused compound is subjected to compressive stress.

1.1 This practice determines the compatibility of plasticizers in poly(vinyl chloride) plastics by rating the amount of plasticizer that spews due to compressional stress set up inside a 180° loop bend.

Note 1: Ingredients other than plasticizer can spew from a total formulation.

1.2 The text of this practice references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this practice.

1.3 The values as stated in SI units are to be regarded as the standard. The values in parentheses are given for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2: There is no known ISO equivalent to this standard.

ASTM D3291-11(2016)e1 Referenced Document

2022 ASTM D3291-22 Standard Practice for Compatibility of Plasticizers in Poly(Vinyl Chloride) Plastics Under Compression
2011 ASTM D3291-11(2016)e1 Standard Practice for Compatibility of Plasticizers in Poly(Vinyl Chloride) Plastics Under Compression
2011 ASTM D3291-11 Standard Practice for Compatibility of Plasticizers in Poly(Vinyl Chloride) Plastics Under Compression
1997 ASTM D3291-97(2003) Standard Practice for Compatibility of Plasticizers in Poly(Vinyl Chloride) Plastics Under Compression
1997 ASTM D3291-97 Standard Practice for Compatibility of Plasticizers in Poly(Vinyl Chloride) Plastics Under Compression