ASTM D1084-16
Standard Test Methods for Viscosity of Adhesives
- Standard No.
- ASTM D1084-16
- Release Date
- 2016
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM D1084-16(2021)
- Latest
- ASTM D1084-16(2021)
- Scope
4.1 Several test methods are noted for viscosity determination of Newtonian and near Newtonian flow characteristics. (For adhesives not fitting into this category, Test Method D2556 should be considered.) Four test methods are covered as follows:
4.1.1 Method A is applicable only to adhesives that will deliver 50 mL in a steady uninterrupted stream from one of the cups described in Section 5.
4.1.2 Method B is intended for measuring the viscosity of adhesives covering a range from 0.05 Pa · s to 200 Pa · s (50 to 200 000 cP) and is limited to materials that have or approach Newtonian flow characteristics.
4.1.3 Method C is intended primarily as a control method for determining the viscosity of adhesives that have or approach Newtonian flow characteristics.
4.1.4 Method D is intended primarily as a control method for determining the viscosity of materials that have an equivalent viscosity no greater than approximately 3000 mPa · s (cP) and is limited to materials that have or approach Newtonian flow characteristics.
1.1 These test methods cover the determination of the viscosity of free-flowing adhesives.
1.1.1 The limitation of this test method to self-leveling adhesives eliminates thixotropic and plastic materials whose viscosity is a function of the rate of stirring and previous history of the adhesive.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D1084-16 Referenced Document
- ASTM D115 Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation
- ASTM D1200 Standard Test Method for Viscosity by Ford Viscosity Cup
- ASTM D1545 Standard Test Method for Viscosity of Transparent Liquids by Bubble Time Method
- ASTM D1601 Standard Test Method for Dilute Solution Viscosity of Ethylene Polymers
- ASTM D2556 Standard Test Method for Apparent Viscosity of Adhesives Having Shear-Rate-Dependent Flow Properties
- ASTM D562 Standard Test Method for Consistency of Paints Measuring Krebs Unit (KU) Visosity Using a Stormer-Type Viscometer
- ASTM D88 Standard Test Method for Saybolt Viscosity
- ASTM D907 Standard Terminology of Adhesives
- ISO 2555 Plastics - Resins in the liquid state or as emulsions or dispersions - Determination of apparent viscosity using a single cylinder type rotational viscometer method
ASTM D1084-16 history
- 2021 ASTM D1084-16(2021) Standard Test Methods for Viscosity of Adhesives
- 2016 ASTM D1084-16 Standard Test Methods for Viscosity of Adhesives
- 2008 ASTM D1084-08 Standard Test Methods for Viscosity of Adhesives
- 1997 ASTM D1084-97(2005) Standard Test Methods for Viscosity of Adhesives
- 1997 ASTM D1084-97 Standard Test Methods for Viscosity of Adhesives
