This European Standard specifies the constructional requirements for heat meters. Heat meters are instruments intended for measuring the energy which in a heat-exchange circuit is absorbed (cooling) or given up (heating) by a liquid called the heat-conveying liquid. The heat meter indicates the quantity of heat in legal units. Electrical safety requirements are not covered by this European Standard. Pressure safety requirements are not covered by this European Standard. Surface mounted temperature sensors are not covered by this European Standard. This standard covers meters for closed systems only, where the differential pressure over the thermal load is limited.
EN 1434-2:2015 Referenced Document
EN 10088-3:2014 Stainless steels - Part 3: Technical delivery conditions for semifinished products@ bars@ rods@ wire@ sections and bright products of corrosion resisting steels for general purposes
EN 1092-1:2007 Flanges and their joints - Circular flanges for pipes, valves, fittings and accessories, PN designated - Part 1: Steel flanges (Incorporates Amendment A1: 2013; Incorporating Corrigendum May 2014)
EN 1092-2:1997 Flanges and their joints - Circular flanges for pipes, valves, fittings and accessories, PN designated - Part 2: Cast iron flanges
EN 1092-3:2003 Flanges and their joints - Circular flanges for pipes, valves, fittings and accessories PN designated - Part 3: Copper alloy flanges
EN 1434-1:2015 Heat Meters - Part 1: General Requirements
EN 1434-3:2008 Heat Meters - Part 3: Data exchange and interfaces*, 2024-04-20 Update
EN 60751:2008 Industrial platinum resistance thermometers and platinum temperature sensors
EN 60947-5-6:2000 Low-Voltage Switchgear and Controlgear Part 5-6: Control Circuit Devices and Switching Elements DC Interface for Proximity Sensors and Switching Amplifiers (NAMUR)
EN ISO 228-1:2003 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation ISO 228-1: 2000
EN ISO 286-2:2010 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)
ISO 4903:1989 Information technology; data communication; 15-pole DTE/DCE interface connector and contact number assignments
EN 1434-2:2015 history
2015EN 1434-2:2015 Heat meters - Part 2: Constructional requirements
2007EN 1434-2:2007 Heat meters - Part 2: Constructional requirements (Incorporating corrigendum October 2007)