ASTM C881/C881M-15 PDF

Scope: 1.1 This specification covers two-component, epoxy-resin bonding systems for application to portland-cement concrete, which are able to cure under humid conditions and bond to damp surfaces.

1.2 This specification does not cover epoxy-resin-base bonding systems that have been modified by addition of components such as cement, fine aggregate, or fiber reinforcement. Additional testing may be required to meet applicable specifications for these applications.

1.3 This specification does not address the effects of creep on epoxy-resin-base bonding systems while under load or the potential for creep rupture. Additional testing is required for applications where creep and creep rupture are critical.

1.4 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Some values have only SI units because the inch-pound equivalents are not used in practice.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Section 9.

ASTM C881/C881M-15 Referenced Document

ASTM C882 Standard Test Method for Bond Strength of Epoxy-Resin Systems Used With Concrete By Slant Shear
ASTM C884/C884M Standard Test Method for Thermal Compatibility Between Concrete and an Epoxy-Resin Overlay
ASTM D2556 Standard Test Method for Apparent Viscosity of Adhesives Having Shear-Rate-Dependent Flow Properties
ASTM D2566 Test Method for Linear Shrinkage of Cured Thermosetting Casting Resins During Cure
ASTM D570 Standard Test Method for Water Absorption of Plastics
ASTM D638 Standard Test Method for Tensile Properties of Plastics
ASTM D648 Standard Test Method for Deflection Temperature of Plastics Under Flexural Load in the Edgewise Position*， 2024-04-20 Update
ASTM D695 Standard Test Method for Compressive Properties of Rigid Plastics

2020 ASTM C881/C881M-20a Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete
2020 ASTM C881/C881M-20 Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete
2015 ASTM C881/C881M-15 Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete
2014 ASTM C881/C881M-14 Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete
2013 ASTM C881/C881M-13 Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete
2010 ASTM C881/C881M-10 Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete
2002 ASTM C881/C881M-02 Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete
1999 ASTM C881-99 Standard Specification for Epoxy-Resin-Base Bonding Systems for Concrete