ASTM D2724-07(2015)
Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
- Standard No.
- ASTM D2724-07(2015)
- Release Date
- 2007
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM D2724-19
- Latest
- ASTM D2724-19
- Scope
5.1 These test methods for the determination of properties of bonded, fused, or laminated apparel fabrics, are considered satisfactory for acceptance testing of commercial shipments of bonded and laminated apparel fabrics since the methods have been used extensively in the trade for acceptance testing.
5.1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing. Randomly assign specimens in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data and a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.
1.1 These test methods cover procedures for characterizing the delamination, strength of bond, appearance, and shrinkage propensity of bonded, fused, and laminated apparel fabrics after drycleaning and laundering.
1.2 The values stated in SI units are to be regarded as standard; the values in parentheses are provided as information only.
1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D2724-07(2015) Referenced Document
- ASTM D123 Standard Terminology Relating to Textiles
- ASTM D1776 Standard Practice for Conditioning and Testing Textiles
- ASTM D4850 Standard Terminology Relating to Fabrics and Fabric Test Methods
- ASTM D76 Standard Specification for Tensile Testing Machines for Textiles
- ASTM E337 Standard Test Method for Measuring Humidity with a Psychrometer (the Measurement of Wet- and Dry-Bulb Temperatures)
ASTM D2724-07(2015) history
- 2019 ASTM D2724-19 Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
- 2007 ASTM D2724-07(2015) Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
- 2007 ASTM D2724-07(2011)e1 Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
- 2007 ASTM D2724-07(2011) Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
- 2007 ASTM D2724-07 Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
- 2003 ASTM D2724-03 Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
- 1987 ASTM D2724-87(2003) Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
- 1987 ASTM D2724-87(1995) Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
