ASTM C661-15 PDF

Scope: 4.1 The results obtained by this test method are simply a measure of the indentation into the sealant material of the indentor under load; they are not generally considered a measure of abrasion or wear resistance of the sealant.

1.1 This test method describes a laboratory procedure for determining indentation hardness of joint sealing compounds, (single- and multicomponent), intended for use in building construction.

1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

1.3 The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations.

1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM C661-15 Referenced Document

ASTM C717 Standard Terminology of Building Seals and Sealants
ASTM D2240 Standard Test Method for Properties of Rubber &8212; Durometer Hardness*， 2024-04-20 Update

2022 ASTM C661-15(2022) Standard Test Method for Indentation Hardness of Elastomeric-Type Sealants by Means of a Durometer
2015 ASTM C661-15 Standard Test Method for Indentation Hardness of Elastomeric-Type Sealants by Means of a Durometer
2006 ASTM C661-06(2011) Standard Test Method for Indentation Hardness of Elastomeric-Type Sealants by Means of a Durometer
2006 ASTM C661-06 Standard Test Method for Indentation Hardness of Elastomeric-Type Sealants by Means of a Durometer
1998 ASTM C661-98 Standard Test Method for Indentation Hardness of Elastomeric-Type Sealants by Means of a Durometer