- Standard No.
- EN ISO 19069-1:2015
- Release Date
- 2015
- Published By
- European Committee for Standardization (CEN)
- Latest
-
EN ISO 19069-1:2015
- Replace
-
FprEN ISO 19069-1:2014
- Scope
- This part of ISO 19069 specifies a naming system for thermoplastic polypropylene (PP) molding compounds which can serve as a basis for specifications. Polypropylene molding compound types are differentiated from one another using a classification system based on appropriate value ranges of the characteristic properties a) tensile elastic modulus, b) Charpy impact strength, and c) melt mass flow rate (MFR) and information about parameters of the base polymers, intended application and/or or processing methods, important properties, additives, dyes, fillers and reinforcing substances. This part of ISO 19069 is applicable to all polypropylene homopolymers and copolymers of propylene with a mass fraction of other 1-olefin monomers of less than 50% (m/m) and to polymer blends with a mass fraction of the above-mentioned polymers of at least 50% (m/ m). It applies to ready-to-use molding materials in the form of powder, granules or pellets and to molding materials modified or unmodified with colorants, additives, fillers, etc. This part of ISO 19069 is not applicable to propylene-based rubber. It cannot be assumed that molding compounds with the same name necessarily have the same performance. This part of ISO 19069 does not contain technical, performance or processing conditions data that may be necessary to specify a molding compound for a particular application and/or processing method. If such additional properties are required, they shall, where possible, be determined in accordance with the test methods specified in ISO 19069-21). In order to specify a thermoplastic molding compound for a particular application or to ensure reproducible processing, additional requirements may be specified in data block 5 (see 3.1).
EN ISO 19069-1:2015 Referenced Document
- ISO 1043-1:2011 Plastics - Symbols and abbreviated terms - Part 1: Basic polymers and their special characteristics
- ISO 1043-2:2011 Plastics - Symbols and abbreviated terms - Part 2: Fillers and reinforcing materials
- ISO 1133-1:2011 Plastics - Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics - Part 1: Standard method
- ISO 1133-2:2011 Plastics - Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics - Part 2: Method for materials sensitive to time-temperature history and/or moisture
EN ISO 19069-1:2015 history
- 2015 EN ISO 19069-1:2015 Plastics - Polypropylene (PP) moulding and extrusion materials - Part 1: Designation system and basis for specifications
EN ISO 19069-1:2015 Plastics - Polypropylene (PP) moulding and extrusion materials - Part 1: Designation system and basis for specifications has been changed from EN ISO 1873-1:1995 Plastics - Polypropylene (PP) Moulding and Extrusion Materials - Part 1: Designation System and Basis for Specifications (ISO 1873-1 : 1995).