ASTM F2649-14 PDF

Scope: 1.1 This specification covers material, design, structural performance, and manufacturing practice requirements for monolithic or sectional corrugated polyethylene grease interceptor tanks with volumes equal to or greater than 333 gal (1,260 L).

1.2 The corrugated high density polyethylene (HDPE) grease interceptor tanks are placed between commercial food service (kitchen) drains and sanitary sewer interceptors to minimize the impact of commercial food service effluent containing grease, oils, soap scum and other typical commercial food service wastes on the sanitary sewer system. Typical sources of commercial kitchen effluent are scullery sinks, pot and pan sinks, dishwashers, soup kettles and floor drains where grease containing materials may exist.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This specification covers pipe and fittings for horizontally laid corrugated HDPE grease interceptor tanks as illustrated in Fig. 1.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F2649-14 Referenced Document

ASTM D1600 Standard Terminology for Abbreviated Terms Relating to Plastics
ASTM D3212 Standard Specification for Joints for Drain and Sewer Plastic Pipes Using Flexible Elastomeric Seals
ASTM D543 Standard Practices for Evaluating the Resistance of Plastics to Chemical Reagents
ASTM F2306/F2306M Standard Specification for 300 mm to 1500 mm [12 in. to 60 in.] Annular Corrugated Profile-Wall Polyethylene (PE) Pipe and Fittings for Non-Pressure Gravity-Flow Storm Sewer and Subsurface Drainage Ap
ASTM F412 Standard Terminology Relating to Plastic Piping Systems
ASTM F477 Standard Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe
ASTM F667 Standard Specification for Large Diameter Corrugated Polyethylene Pipe and Fittings
ASTM F714 Standard Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Outside Diameter

2023 ASTM F2649-14(2023) Standard Specification for Corrugated High Density Polyethylene (HDPE) Grease Interceptor Tanks
2019 ASTM F2649-14(2019) Standard Specification for Corrugated High Density Polyethylene (HDPE) Grease Interceptor Tanks
2014 ASTM F2649-14 Standard Specification for Corrugated High Density Polyethylene &40;HDPE&41; Grease Interceptor Tanks
2008 ASTM F2649-08a Standard Specification for Corrugated High Density Polyethylene (HDPE) Grease Interceptor Tanks
2008 ASTM F2649-08 Standard Specification for Corrugated High Density Polyethylene (HDPE) Grease Interceptor Tanks