ASTM D2511-93(2014) PDF

Scope: 5.1 Solid lubricant coatings are applied to surfaces that are exposed to heat and cold to such a degree that in many cases liquid lubricants are not practical. Adherence under these conditions is mandatory to preserve the bearing surfaces during sliding motion.

1.1 This test method covers the measurement of the resistance of dry solid film lubricants to deterioration when subjected to temperature extremes.

1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D2511-93(2014) Referenced Document

ASTM A167 Standard Specification for Stainless and Heat-Resisting Chromium-Nickel Steel Plate, Sheet, and Strip *， 1999-04-20 Update
ASTM D2510 Standard Test Method for Adhesion of Solid Film Lubricants*， 2017-10-01 Update
ASTM D4175 Standard Terminology Relating to Petroleum Products, Liquid Fuels, and Lubricants*， 2023-07-01 Update

2020 ASTM D2511-20 Standard Test Method for Thermal Shock Sensitivity of Solid Film Lubricants
2019 ASTM D2511-93(2019) Standard Test Method for Thermal Shock Sensitivity of Solid Film Lubricants
1993 ASTM D2511-93(2014) Standard Test Method for Thermal Shock Sensitivity of Solid Film Lubricants
2009 ASTM D2511-93(2009) Standard Test Method for Thermal Shock Sensitivity of Solid Film Lubricants
1993 ASTM D2511-93(2003) Standard Test Method for Thermal Shock Sensitivity of Solid Film Lubricants
1993 ASTM D2511-93(1998)e1 Standard Test Method for Thermal Shock Sensitivity of Solid Film Lubricants