ASTM D3270-13
Standard Test Methods for Analysis for Fluoride Content of the Atmosphere and Plant Tissues lpar;Semiautomated Methodrpar;

Standard No.

ASTM D3270-13

Release Date

2013

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D3270-13(2021)

Latest

ASTM D3270-13(2021)

Scope

5.1 These test methods may be used for determining the fluoride content of particulate matter and gases collected from the atmosphere by passive and active means, including plant tissues. The user is warned that the fluoride content of passive collectors (including plants) give only qualitative or semiquantitative measurement of atmospheric fluoride content.

1.1 These test methods describe the semiautomated procedure for the analyses of various types of samples for the purpose of determining total fluoride. Since the test methods incorporate microdistillation of the sample, they may be applied to any fluoride-containing solution where standards of identical composition have been carried through the same sample preparation procedures and have proven to provide quantitative recovery when analyzed by the semiautomated system. Conversely, the methods shall not be applied for analyses until the applicability has been demonstrated.

1.2 In normal use, the procedure can detect 0.1 μg/mL of F. The normal range of analysis is from 0.1 to 1.6 μg/mL of F. Higher concentrations can be analyzed by careful dilution of samples with reagent water. If digested samples routinely exceed 1.6 μg/mL of F, the analytical portion of the pump manifold can be modified to reduce sensitivity. However, the best procedure is to analyze a smaller aliquot of the sample. Most accurate results are obtained when the fluoride concentration falls in the middle or upper part of the calibration curve.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 8.3, 10.2.4, and 10.2.5 for additional precautions.

ASTM D3270-13 Referenced Document

• ASTM D1193 Standard Specification for Reagent Water
• ASTM D1356 Standard Terminology Relating to Sampling and Analysis of Atmospheres*， 2024-04-20 Update
• ASTM D3266 Standard Test Method for Automated Separation and Collection of Particulate and Acidic Gaseous Fluoride in the Atmosphere (Double Paper Tape Sampler Method)
• ASTM D3267 Standard Test Method for Separation and Collection of Particulate and Water-Soluble Gaseous Fluorides in the Atmosphere (Filter and Impinger Method)
• ASTM D3268 Standard Test Method for Separation and Collection of Particulate and Gaseous Fluorides in the Atmosphere (Sodium Bicarbonate-Coated Glass Tube and Particulate Filter Method)
• ASTM D3269 Standard Test Methods for Analysis for Fluoride Content of the Atmosphere and Plant Tissues (Manual Procedures)
• ASTM D3614 Standard Guide for Laboratories Engaged in Sampling and Analysis of Atmospheres and Emissions

ASTM D3270-13 history

• 2021 ASTM D3270-13(2021) Standard Test Methods for Analysis for Fluoride Content of the Atmosphere and Plant Tissues (Semiautomated Method)
• 2013 ASTM D3270-13 Standard Test Methods for Analysis for Fluoride Content of the Atmosphere and Plant Tissues lpar;Semiautomated Methodrpar;
• 2000 ASTM D3270-00(2006) Standard Test Methods for Analysis for Fluoride Content of the Atmosphere and Plant Tissues (Semiautomated Method)
• 2000 ASTM D3270-00 Standard Test Methods for Analysis for Fluoride Content of the Atmosphere and Plant Tissues (Semiautomated Method)
• 1991 ASTM D3270-91(1995)e1 Standard Test Methods for Analysis for Fluoride Content of the Atmosphere and Plant Tissues (Semiautomated Method)
• 1991 ASTM D3270-91e1 Standard Method for Analysis for Fluoride Content of the Atmosphere and Plant Tissues (Semiautomated Method)
• 1980 ASTM D3270-80 Standard Method for Analysis for Fluoride Content of the Atmosphere and Plant Tissues (Semiautomated Method)