ASTM F3006-13
Standard Specification for Ball Drop Impact Resistance of Laminated Architectural Flat Glazing
- Standard No.
- ASTM F3006-13
- Release Date
- 2013
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM F3006-19
- Latest
- ASTM F3006-20
- Scope
1.1 This specification covers the destructive ball drop testing of laminated flat glass products intended for use in architectural glazing applications.
1.2 This specification is intended for use as an in-plant quality control test to evaluate the impact performance of laminated flat glass when a 2.3 kg, 83 mm diameter smooth solid steel ball is dropped from a specified height.
1.3 This specification does not yield data that is a substitute for safety glazing test requirements of ANSI Z97.1 or CPSC 16 CFR 1201. Qualification under this specification provides a basis for judgment of the ability of specimens to withstand the appropriate shot-bag impact. This specification provides a mechanism to allow fabricators a less cumbersome and lower cost method for the evaluation of impact performance that may be performed on a frequent basis while reducing the amount of waste materials generated from traditional impact tests.
1.4 This specification is applicable to symmetrical and asymmetrical annealed, heat-strengthened, chemically strengthened, fully tempered laminated architectural flat glass including but not limited to: float, patterned, sheet, sand-blasted, grooved, and fritted.
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Section 4 on Hazards.
ASTM F3006-13 Referenced Document
- ASTM C1036 Standard Specification for Flat Glass
- ASTM C1048 Standard Specification for Heat-Treated Flat Glass--Kind HS, Kind FT Coated and Uncoated Glass
- ASTM C1172 Standard Specification for Laminated Architectural Flat Glass
- ASTM C1422 Standard Specification for Chemically Strengthened Flat Glass
- ASTM C162 Standard Terminology of Glass and Glass Products
- ASTM E631 Standard Terminology of Building Constructions
ASTM F3006-13 history
- 2020 ASTM F3006-20 Standard Specification for Ball Drop Impact Resistance of Laminated Architectural Flat Glazing
- 2019 ASTM F3006-19 Standard Specification for Ball Drop Impact Resistance of Laminated Architectural Flat Glazing
- 2013 ASTM F3006-13 Standard Specification for Ball Drop Impact Resistance of Laminated Architectural Flat Glazing
