EN 302-6:2013 Adhesives for load-bearing timber structures - Test methods - Part 6: Determination of the minimum pressing time under referenced conditions
This European Standard specifies a method of determining the minimum pressing time for two glue line thicknesses, close contact glue line and 0,3 mm thick glue line (for gap filling adhesive 1,0 mm), at three temperatures. It is applicable to adhesives used in load-bearing timber structures. This European Standard is only intended for obtaining a reliable base of comparison of pressing time between adhesives. The method gives results that cannot be applied to the safe manufacture of timber structures without modifications for the influences of timber density/absorbency, moisture content, factory temperature and relative air humidity.
EN 302-6:2013 Referenced Document
EN 302-1:2013 Adhesives for load-bearing timber structures - Test methods - Part 1: Determination of longitudinal tensile shear strength
ISO 5893:2002 Rubber and plastics test equipment - Tensile, flexural and compression types (constant rate of traverse) - Specification
EN 302-6:2013 history
2023EN 302-6:2023 Adhesives for load-bearing timber structures - Test methods - Part 6: Determination of the minimum pressing time under referenced conditions
2013EN 302-6:2013 Adhesives for load-bearing timber structures - Test methods - Part 6: Determination of the minimum pressing time under referenced conditions
2004EN 302-6:2004 Adhesives for load-bearing timber structures - Test methods - Part 6: Determination of the conventional pressing time