SAE AMS2516E-2013 PDF

Scope: This specification establishes the engineering requirements for producing thick coatings of polytetrafluoroethylene (PTFE) resin on parts and the properties of such coatings. Primarily to provide dry lubrication, high heat stability, and corrosion protection on parts which operate at not higher than 527 degrees F (275 degrees C) for limited periods or not higher than 473 degrees F (245 degrees C) for extended periods. This coating is usually smoother than that of AMS 2515. This coating may also be used as a release film for molds.

SAE AMS2516E-2013 Referenced Document

ASTM A108-07 Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished*， 2024-04-20 Update
ASTM B117-11 Standard Practice for Operating Salt Spray (Fog) Apparatus*， 2024-04-20 Update
SAE AMS5045 STEEL SHEET AND STRIP Low Carbon - Hard Temper

2018 SAE AMS2516F-2018 Polytetrafluoroethylene (PTFE) Resin Coating High Build@ 698 to 752 °F (370 to 400 °C) Fusion.
2013 SAE AMS2516E-2013 Polytetrafluoroethylene (PTFE) Resin Coating, High Build, 698-752°F (370-400°C) Fusion
2003 SAE AMS2516D-2003 Polytetrafluoroethylene (PTFE) Resin Coating High Build, 370 to 400 °C (698 to 752 °F) Fusion
2003 SAE AMS2516C-2003 Polytetrafluoroethylene (PTFE) Resin Coating High Build, 370 to 400 °C (698 to 752 °F) Fusion
1990 SAE AMS2516D-1990 Polytetrafluoroethylene (PTFE) Resin Coating High Build, 370 Degrees - 400 Degrees C (698 Degrees - 752 Degrees F) Fusion
1983 SAE AMS2516C-1983 POLYTETRAFLUOROETHYLENE RESIN COATING High Build@ 370° - 400°c (700° - 750°) Fusion
1974 SAE AMS2516B-1974 POLYTETRAFLUOROETHYLENE RESIN COATING High Build, 700° - 750° F (371° - 399° C) Fusion
1965 SAE AMS2516A-1965 POLYTETRAFLUOROETHYLENE RESIN COATING High Build, 700 - 750 F (371 - 399 C) Fusion
1963 SAE AMS2516-1963 POLYTETRAFLUOROETHYLENE RESIN COATING High Build, 700 - 750 F (370 - 400 C) Fusion