This SAE Aerospace Recommended Practice (ARP) is intended as a guide to aid in the specification and testing of Direct Drive Servovalves, but does not include the associated electronic controller. The recommendations contained in this ARP are primarily confined to the input and output characteristics of Direct Drive Servovalves (DDV). The only exception to this approach involves the definition and specification of chip shear force, which is not typically measurable by nondestructive external testing. The information presented should be useful in standardizing the terminology, the specification of physical and performance parameters, and the test procedures
SAE ARP4493A-2013 Referenced Document
SAE ARP1281 SERVOACTUATORS: AIRCRAFT FLIGHT CONTROLS, POWER OPERATED, HYDRAULIC, GENERAL SPECIFICATION FOR
SAE ARP1383 IMPULSE TESTING OF HYDRAULIC ACTUATORS@ VALVES@ PRESSURE CONTAINERS AND SIMILAR FLUID SYSTEM COMPONENTS
SAE ARP4386 TERMINOLOGY AND DEFINITIONS FOR AEROSPACE FLUID POWER, ACTUATION, AND CONTROL TECHNOLOGIES
SAE AS1241 AS1241 Shaft, Trim Control - Direct Drive
SAE AS4059 AEROSPACE-CLEANLINESS CLASSIFICATION FOR HYDRAULIC FLUIDS
SAE AS4536 SAFETY CABLE KIT PROCUREMENT SPECIFICATION AND REQUIREMENTS FOR USE
SAE AS4941-1998 Aerospace - General Requirements for Commercial Aircraft Hydraulic Components
SAE AS5440-1998 Hydraulic Systems, Aircraft, Design and Installation Requirements for FSC 1650; Should Be Used Instead of MIL-H-5440H, Which Was Cancelled on 13 September 1999
SAE J2470-2009 Hydraulic Fluid Power Valves Method for Assessing the Lock Sensitivity to Contaminants