ASTM D5478-13
Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer

Standard No.

ASTM D5478-13

Release Date

2013

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5478-13(2018)

Latest

ASTM D5478-13(2022)

Scope

5.1 These test methods are applicable for measuring the rheological properties of varnishes and paints. In particular, the low to moderate shear rate measurements provide information related to sag resistance, leveling, etc.

1.1 These test methods cover the measurement of the viscosity of Newtonian and non-Newtonian liquids. These test methods are applicable to liquids having viscosities in the range from 58201;×8201;10⁻⁴ to 10³ Pa·s (0.5 to 10⁶ cP). The shear rate range is dependent upon the needle used and viscosity of the liquid and may vary from 10⁻⁴ to 10³ s⁻¹. With an extension bar and applied weight, a shear rate of 10⁴ s^–1 may be achieved.

1.2 The yield stress of liquids having this property may also be determined.

1.3 These test methods consist of determining liquid viscosities of Newtonian and non-Newtonian fluids (clear or opaque) by measuring the steady-state (constant) or terminal velocities of cylindrical needles as they fall through the test liquid under the influence of gravity. Yield stresses of non-Newtonian liquids may be measured using the same procedure.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5478-13 Referenced Document

• ASTM E1 Standard Specification for ASTM Thermometers
• ASTM E2251 Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids

ASTM D5478-13 history

• 2022 ASTM D5478-13(2022) Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer
• 2018 ASTM D5478-13(2018) Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer
• 2013 ASTM D5478-13 Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer
• 2009 ASTM D5478-09 Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer
• 1998 ASTM D5478-98(2003) Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer
• 1998 ASTM D5478-98 Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer