This standard specifies electromechanical switches for electrical and electronic equipment. Switches to which this standard applies: a) devices for breaking, making or switching circuit connections by means of mechanical movement of conductive parts (contacts); b) a maximum rated voltage of 480V; c) a maximum rated current of 63A. This section does not apply to keyboards and keypads for information handling systems. This standard is also applicable to electromechanical key (key) switches. Switch families will be described in detail specifications corresponding to this master specification.
GB/T 9536-2012 Referenced Document
GB 15092.1-2010 Switches for appliances—Part 1:General requirements
GB 3100-1993 SI units and recommendations for the use of their multiples and of certain other units
GB 4208-2008 Degrees of protection provided by enclosure(IP code)
GB/T 2421.1-2008 Environmental testing for electric and electronic products.General and guidance
GB/T 2423.1-2008 Environmental testing for electric and electronic products.Part 2:Test methods.Tests A:Cold
GB/T 2423.16-2008 Environmental testing for electric and electronic products.Part 2:Test methods.Test J and guidance:Mould growth
GB/T 2423.2-2008 Environmental testing for electric and electronic products.Part 2:Test methods.Tests B:Dry heat
GB/T 2423.21-2008 Environmental testing for electric and electronic products.Part 2 Test methods Test M:Low air pressure
GB/T 2423.3-2006 Environmental testing for electric and electronic products-Part 2:Tesing method-Test Cab:Damp heat,steady state
GB/T 2423.30-1999 Environmental testing for electric and electronic products-- Part 2: Test methods Test XA and guidance:immersion in cleaning solvents
GB/T 2423.37-2006 Environmental testing for electric and electronic products Part 2: Test methods Test L: Dust and sand
GB/T 2423.4-2008 Environmental testing for electrical and electronic products - Part 2: Test method Test Db alternating damp heat (12h + 12h cycle)
GB/T 2423.45-1997 Environmental testing for electric and electronic products. Part 2: Test methods. Test Z/ABDM: Climatic sequence
GB/T 2423.60-2008 Environmental testing for electric and electronic products.Part 2:Test methods.Test U:Robustness of terminations and integral mounting devices
GB/T 4728.13-2008 Graphical symbols for diagrams.Part 13:Analogue elements
GB/T 9536-2012 history
2012GB/T 9536-2012 Electromechanical switches for use in electrical and electronic equipment.Part 1:Generic specification
1995GB/T 9536-1995 Electromechanical switches for use in electronic equipment. Part 1: Generic specification