ASTM D2580-06(2012)
Standard Test Method for Phenols in Water by Gas-Liquid Chromatography

Standard No.

ASTM D2580-06(2012)

Release Date

2006

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM D2580-06(2012)

Scope

Phenolic compounds are sometimes found in surface waters from natural and industrial sources. Chlorination of such waters may produce odoriferous, objectionable tasting chlorophenols. These compounds may include o-chlorophenol, p-chlorophenol, 2,6-dichlorophenol, and 2,4-dichlorophenol.

1.1 This test method covers a direct aqueous injection procedure for the gas-liquid chromatographic determination of phenols, cresols, and mono- and di-chlorophenols in water.

1.2 The precision and bias of the test method has been calculated from the results of interlaboratory analyses of three master solutions, each containing phenol, p-cresol, p-chlorophenol, 3,5-dichlorophenol.

1.3 The test method may be applied to waste water or concentrates that contain more than 1 mg/L of phenolic compounds. Therefore, for a comparison with Test Methods D1783, see Appendix X1.

1.4 The analyst should recognize that precision statements provided in 17.1 and 17.2 may not apply to waters of other matrices.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Note 3."s00005">1.4 The guide is applicable to either packed or capillary column gas chromatography, including wide-bore capillary columns. Because of their greatly enhanced resolution, capillary columns are strongly recommended.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D2580-06(2012) Referenced Document

• ASTM D1129 Standard Terminology Relating to Water
• ASTM D1193 Standard Specification for Reagent Water
• ASTM D1783 Standard Test Methods for Phenolic Compounds in Water
• ASTM D3370 Standard Practices for Sampling Water from Closed Conduits
• ASTM D3856 Standard Guide for Good Laboratory Practices in Laboratories Engaged in Sampling and Analysis of Water
• ASTM D4210 Standard Practice for Intralaboratory Quality Control Procedures and a Discussion on Reporting Low-Level Data
• ASTM E260 Standard Practice for Packed Column Gas Chromatography
• ASTM E355 Standard Practice for Gas Chromatography Terms and Relationships*， 2024-04-20 Update

ASTM D2580-06(2012) history

• 2006 ASTM D2580-06(2012) Standard Test Method for Phenols in Water by Gas-Liquid Chromatography
• 2006 ASTM D2580-06 Standard Test Method for Phenols in Water by Gas-Liquid Chromatography
• 1994 ASTM D2580-94(2001) Standard Test Method for Phenols in Water by Gas-Liquid Chromatography
• 2001 ASTM D2580-94 Standard Test Method for Phenols in Water by Gas-Liquid Chromatography