This International Standard specifies the approach to be followed when developing procedures for the ultrasonic testing of the following welds:
— welds in stainless steels;
— welds in nickel-based alloys;
— welds in duplex steels;
— dissimilar metal welds;
— austenitic welds.
The purposes of the testing can be very different, e.g.:
— for the assessment of quality level (manufacturing);
— for the detection of specific indications induced in service.
Acceptance levels are not included in this International Standard, but can be applied in accordance with the scope of the testing (see Clause 5).
The requirements of this International Standard are applicable to both manual and mechanized testing.
ISO 22825:2012 Referenced Document
EN 12668-1 Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 1: Instruments
EN 12668-2 Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 2: Probes
EN 12668-3 Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 3: Combined equipment*, 2024-04-19 Update
EN 473 Non-destructive testing - Qualification and certification of NDT personnel - General principles
ISO 17635 Non-destructive testing of welds - General rules for metallic materials*, 2016-12-01 Update
ISO 17640 Non-destructive testing of welds - Ultrasonic testing - Techniques, testing levels, and assessment*, 2018-09-30 Update