ASTM D5450/D5450M-12
Standard Test Method for Transverse Tensile Properties of Hoop Wound Polymer Matrix Composite Cylinders

Standard No.

ASTM D5450/D5450M-12

Release Date

2012

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5450/D5450M-16

Latest

ASTM D5450/D5450M-22

Scope

This test method is used to produce transverse tensile property data for material specifications, research and development, quality assurance, and structural design and analysis. Factors which influence the transverse tensile response and should, therefore, be reported are: material, methods of material preparation, specimen preparation, specimen conditioning, environment of testing, specimen alignment and gripping, speed of testing, void content, and fiber volume fraction. Properties, in the test direction, which may be obtained from this test method include:

Transverse Tensile Strength,

Transverse Tensile Strain at Failure,

Transverse Tensile Modulus of Elasticity, E₂₂, and

Poisson's Ratio, υ₂₁.

1.1 This test method determines the transverse tensile properties of wound polymer matrix composites reinforced by high-modulus continuous fibers. It describes testing of hoop wound (90°) cylinders in axial tension for determination of transverse tensile properties.

1.2 The technical content of this standard has been stable since 1993 without significant objection from its stakeholders. As there is limited technical support for the maintenance of this standard, changes since that date have been limited to items required to retain consistency with other ASTM D30 Committee standards, including editorial changes and incorporation of updated guidance on specimen preconditioning and environmental testing. The standard, therefore, should not be considered to include any significant changes in approach and practice since 1993. Future maintenance of the standard will only be in response to specific requests and performed only as technical support allows.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3.1 Within the text, the inch-pound units are shown in brackets.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5450/D5450M-12 history

• 2022 ASTM D5450/D5450M-22 Standard Test Method for Transverse Tensile Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 2016 ASTM D5450/D5450M-16 Standard Test Method for Transverse Tensile Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 2012 ASTM D5450/D5450M-12 Standard Test Method for Transverse Tensile Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 2011 ASTM D5450/D5450M-11 Standard Test Method for Transverse Tensile Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 1993 ASTM D5450/D5450M-93(2006) Standard Test Method for Transverse Tensile Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 1993 ASTM D5450/D5450M-93(2000) Standard Test Method for Transverse Tensile Properties of Hoop Wound Polymer Matrix Composite Cylinders
• 2000 ASTM D5450/D5450M-93 Standard Test Method for Transverse Tensile Properties of Hoop Wound Polymer Matrix Composite Cylinders