ASTM C1328/C1328M-12
Standard Specification for Plastic (Stucco) Cement

Standard No.
ASTM C1328/C1328M-12
Release Date
2012
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM C1328/C1328M-19
Latest
ASTM C1328/C1328M-23
Scope

1.1 This specification covers two types of plastic cement for use in portland cement-based plasters for exterior (stucco) and interior application.

1.2 Units8212;The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Values in SI units shall be obtained by measurement in SI units or by appropriate conversion, using the Rules for Conversion and Rounding given in Standard , of measurements made in other units. Values are stated in only SI units when inch-pound units are not used in practice.

1.3 The text of this standard refers to notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.4 The following safety hazards caveat pertains only to Sections 14 and 15. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (WarningFresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.)

ASTM C1328/C1328M-12 Referenced Document

  • ASTM C109/C109M Standard Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)
  • ASTM C1506 Standard Test Method for Water Retention of Hydraulic Cement-Based Mortars and Plasters
  • ASTM C151 Standard Test Method for Autoclave Expansion of Hydraulic Cement
  • ASTM C183 Standard Practice for Sampling and the Amount of Testing of Hydraulic Cement
  • ASTM C185 Standard Test Method for Air Content of Hydraulic Cement Mortar
  • ASTM C187 Standard Test Method for Normal Consistency of Hydraulic Cement
  • ASTM C188 Standard Test Method for Density of Hydraulic Cement
  • ASTM C219 Standard Terminology Relating to Hydraulic and Other Inorganic Cements
  • ASTM C266 Standard Test Method for Time of Setting of Hydraulic-Cement Paste by Gillmore Needles
  • ASTM C305 Standard Practice for Mechanical Mixing of Hydraulic Cement Pastes and Mortars of Plastic Consistency
  • ASTM C430 Standard Test Method for Fineness of Hydraulic Cement by the 45-956;m (No. 325) Sieve
  • ASTM C511 Standard Specification for Moist Cabinets, Moist Rooms, and Water Storage Tanks Used in the Testing of Hydraulic Cements and Concretes
  • ASTM C778 Standard Specification for Standard Sand
  • ASTM C926 Standard Specification for Application of Portland Cement-Based Plaster
  • IEEE/ASTM SI 10 American National Standard for Metric Practice

ASTM C1328/C1328M-12 history

Standard Specification for Plastic (Stucco) Cement


Copyright ©2024 All Rights Reserved