DIN EN ISO 293:2005 PDF

Scope: This standard specifies the general principles and the procedures to be followed with thermoplastics in the preparation of compression-moulded test specimens, and sheets from which test specimens may be machined or stamped. In order to obtain mouldings in a reproducible state, the main steps of the procedure, including four different cooling methods, are standardized. For each material, the required moulding temperature and cooling methods are as specified in the appropriate International Standard for the material or as agreed between the interested parties. The procedure is not recommended for reinforced thermoplastics.

DIN EN ISO 293:2005 Referenced Document

ISO 286-1 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 1: Basis of tolerances, deviations and fits; Technical Corrigendum 1*， 2013-08-01 Update
ISO 4287 Geometrical product specifications (GPS) — Surface finish: Profile method — Surface finish terms, definitions and parameters — Amendment 2: .

2023 DIN EN ISO 293:2023-10 Plastics - Compression moulding of test specimens of thermoplastic materials (ISO 293:2023); German version EN ISO 293:2023
2023 DIN EN ISO 293:2023-06 Plastics - Compression moulding of test specimens of thermoplastic materials (ISO 293:2023); German version EN ISO 293:2023
2023 DIN EN ISO 293:2023 Plastics - Compression moulding of test specimens of thermoplastic materials (ISO 293:2023)
2005 DIN EN ISO 293:2005 Plastics - Compression moulding of test specimens of thermoplastic materials (ISO 293:2004); English version of DIN EN ISO 293
2003 DIN EN ISO 293:2003 Plastics — Compression molding test specimens of thermoplastic materials