ASTM B75/B75M-11
Standard Specification for Seamless Copper Tube

Standard No.
ASTM B75/B75M-11
Release Date
2011
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM B75/B75M-19
Latest
ASTM B75/B75M-20
Scope

1.1 This specification establishes the requirements for seamless round, rectangular, and square copper tube suitable for general engineering applications.

1.1.1 Tubes made from any of the following Copper UNS No. designations shall be supplied unless otherwise specified in the contract or purchase order:

Copper UNS No.Type of Copper
C10100Oxygen-free electronic
C10200Oxygen-free without residual deoxidants
C10300Oxygen-free, extra low phosphorus
C10800Oxygen-free, low phosphorus
C12000Phosphorus deoxidized, low residual phosphorus
C12200Phosphorus deoxidized, high residual phosphorus

1.2 Units8212;The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 The following hazard statement pertains only to the test methods described in Sections 20.5.2.1, 21.2.9, and 21.2.10 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM B75/B75M-11 Referenced Document

  • ASTM B153 Standard Test Method for Expansion (Pin Test) of Copper and Copper-Alloy Pipe and Tubing
  • ASTM B170 Standard Specification for Oxygen-Free Electrolytic Copper Refinery Shapes*， 2024-04-19 Update
  • ASTM B193 Standard Test Method for Resistivity of Electrical Conductor Materials
  • ASTM B251 Standard Specification for General Requirements for Wrought Seamless Copper and Copper-Alloy Tube
  • ASTM B251M Standard Specification for General Requirements for Wrought Seamless Copper and Copper-Alloy Tube [Metric]
  • ASTM B577 Standard Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper
  • ASTM B601 Standard Classification for Temper Designations for Copper and Copper Alloys-Wrought and Cast
  • ASTM B846 Standard Terminology for Copper and Copper Alloys
  • ASTM E112 Standard Test Methods for Determining Average Grain Size
  • ASTM E18 Standard Test Methods for Rockwell Hardness of Metallic Materials
  • ASTM E243 Standard Practice for Electromagnetic (Eddy-Current) Examination of Copper and Copper-Alloy Tubes
  • ASTM E255 Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
  • ASTM E3 Standard Practice for Preparation of Metallographic Specimens
  • ASTM E527 Standard Practice for Numbering Metals and Alloys (UNS)
  • ASTM E53 Standard Test Method for Determination of Copper in Unalloyed Copper by Gravimetry
  • ASTM E62 Standard Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)
  • ASTM E8/E8M Standard Test Methods for Tension Testing of Metallic Materials

ASTM B75/B75M-11 history

Standard Specification for Seamless Copper Tube


Copyright ©2024 All Rights Reserved