This standard specifies the ultrasonic testing methods and results evaluation of alloy bearing bushes of turbine generators in service. This standard is applicable to the inspection during installation and maintenance of tin-based and lead-based alloy bearing bushes with a thickness of not less than 1mm. This standard is not applicable to the detection of the area within the radius of the probe from the edge of the bearing bush, oil hole and oil groove. If there is a dovetail groove on the bearing joint surface, it is not applicable to the detection of the area along the edge of the dovetail groove.
DL/T 297-2011 Referenced Document
DL/T 675 Examination codes for qualification of non-destructive testing personnel of electric power industry*, 2014-10-15 Update
JB/T 10061 Commonly used specification for A-mode ultrasonic flaw detector using pulse echo technique
JB/T 10062 Testing methods for performance of probes used in ultrasonic flaw detection
JB/T 9214 Non-destructive testing.Test methods for evaluating performance characteristics of A-scan pulse-echo ultrasonic testing systems
DL/T 297-2011 history
2023DL/T 297-2023 Ultrasonic testing of turbine generator alloy bearings
2011DL/T 297-2011 The ultrasonic testing for alloy bearing of in-service turbo-generator