ASTM D5006-11
Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels

Standard No.

ASTM D5006-11

Release Date

2011

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5006-11(2016)

Latest

ASTM D5006-11(2021)

Scope

DiEGME is miscible with water and can be readily extracted from the fuel by contact with water during shipping and in storage. Methods are therefore needed to check the additive content in the fuel to ensure proper additive concentration in the aircraft.

This test method is applicable to analyses performed in the field or in a laboratory.

1.1 This test method covers a technique for measuring the concentration of Diethylene Glycol Monomethyl Ether (DiEGME) in aviation fuels. A measured volume of fuel, extracted with a fixed ratio of water, is tested with a suitable refractometer to determine the concentration of fuel system icing inhibitor (FSII) in fuel. Precision estimates have been determined for the DiEGME additive using specific extraction ratios with a wide variety of fuel types. The extraction ratios are high enough that portable handheld refractometers can be used, but not so high as to sacrifice accuracy or linearity, or both, in the 0.01 to 0.25 vol % range of interest.

1.2 DiEGME is fully described in Specification D4171 and in other specifications.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 WARNINGMercury has been designated by many regulatory agencies as a hazardous material that can cause central nervous system, kidney and liver damage. Mercury, or its vapor, may be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercury containing products. See the applicable product Material Safety Data Sheet (MSDS) for details and EPA’s websitehttp://www.epa.gov/mercury/faq.htmfor additional information. Users should be aware that selling mercury and/or mercury containing products into your state or country may be prohibited by law.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5006-11 history

• 2021 ASTM D5006-11(2021) Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels
• 2011 ASTM D5006-11(2016) Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels
• 2011 ASTM D5006-11 Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels
• 2010 ASTM D5006-10e1 Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels
• 2010 ASTM D5006-10 Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels
• 2003 ASTM D5006-03 Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels
• 2002 ASTM D5006-02 Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels
• 1996 ASTM D5006-96(2001) Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels
• 1996 ASTM D5006-96 Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels