ASTM C1644-06(2011)
Standard Specification for Resilient Connectors Between Reinforced Concrete On-Site Wastewater Tanks and Pipes

Standard No.

ASTM C1644-06(2011)

Release Date

2006

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM C1644-06(2017)

Latest

ASTM C1644-06(2017)

Scope

1.1 This specification covers the minimum performance and material requirements for resilient connectors used for connections between reinforced concrete tanks used for septic effluent treatment/detention, including those referenced in Specifications C913 and C1227.

1.1.1 These connectors are designed to eliminate leakage between the pipe(s) and tank.

1.2 A complete metric companion to Specification C1644 has been developedC1644M; therefore, no metric equivalents are presented in this specification.

Note 18212;This specification covers the design, material, and performance of the resilient connection only. Connections covered by this specification are adequate for hydrostatic pressures up to 5 psi (11.5 ft) without leakage when tested in accordance with Section 7. Infiltration or exfiltration quantities for an installed system are dependent upon many factors other than the connectors between tanks and pipes, and allowable quantities must be covered by other specifications and suitable testing of the installed pipe and system.

1.3 The following precautionary caveat pertains only to the test methods portion, Section 7, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM C1644-06(2011) Referenced Document

• ASTM A240/A240M Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
• ASTM C1227 Standard Specification for Precast Concrete Septic Tanks
• ASTM C822 Standard Terminology Relating to Concrete Pipe and Related Products
• ASTM C913 Standard Specification for Precast Concrete Water and Wastewater Structures
• ASTM D1149 Standard Test Method for Rubber Deterioration-Surface Ozone Cracking in a Chamber
• ASTM D1566 Standard Terminology Relating to Rubber
• ASTM D2240 Standard Test Method for Properties of Rubber &8212; Durometer Hardness*， 2024-04-19 Update
• ASTM D395 Standard Test Methods for Rubber Property-Compression Set
• ASTM D412 Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers8212;Tension
• ASTM D471 Standard Test Method for Rubber Property-Effect of Liquids
• ASTM D543 Standard Practices for Evaluating the Resistance of Plastics to Chemical Reagents
• ASTM D573 Standard Test Method for Rubber-Deterioration in an Air Oven
• ASTM D624 Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers
• ASTM D746 Standard Test Method for Brittleness Temperature of Plastics and Elastomers by Impact
• ASTM D883 Standard Terminology Relating to Plastics

ASTM C1644-06(2011) history

• 2006 ASTM C1644-06(2017) Standard Specification for Resilient Connectors Between Reinforced Concrete On-Site Wastewater Tanks and Pipes
• 2006 ASTM C1644-06(2011) Standard Specification for Resilient Connectors Between Reinforced Concrete On-Site Wastewater Tanks and Pipes
• 2006 ASTM C1644-06 Standard Specification for Resilient Connectors Between Reinforced Concrete On-Site Wastewater Tanks and Pipes