DIN EN 14154-1:2011 PDF

Scope: This document applies to water meters intended for residential, commercial, light industrial and industrial use, and specifies the requirements and certification procedures for water meters, irrespective of the design technologies used to meter the actual volume of clean cold potable water or heated water, flowing through a fully charged, closed conduit. These water meters shall incorporate devices, which indicate the integrated volume. This document also applies to water meters based on electrical or electronic principles, and to water meters based on mechanical principles incorporating electronic devices, used to meter the actual volume flow of cold potable water or heated water. It provides metrological requirements for electronic ancillary devices when they are subject to metrological control. As a rule the ancillary devices are optional. However national or international regulations make some ancillary devices mandatory in relation to the utilisation of the water meter.

DIN EN 14154-1:2011 Referenced Document

EN 1333:1996 Pipework Components - Definition and Selection of PN
EN ISO 6708:1995 Pipework Components - Definition and Selection of DN (Nominal Size) (ISO 6708 : 1995)
ISO 3:1973 Preferred numbers; Series of preferred numbers
ISO 7005-2:1988 Metallic flanges; part 2: cast iron flanges
ISO 7005-3:1988 Metallic flanges; part 3: copper alloy and composite flanges

2014 DIN EN ISO 4064-1:2014 Water meters for cold potable water and hot water - Part 1: Metrological and technical requirements (ISO 4064-1:2014); German version EN ISO 4064-1:2014
2011 DIN EN 14154-1:2011 Water meters - Part 1: General requirements; German version EN 14154-1:2005+A2:2011
2007 DIN EN 14154-1:2007 Water meters - Part 1: General requirements German version EN 14154-1:2005+A1:2007
1970 DIN EN 14154-1 E:2001-08 Water meters - Part 1: General requirements