ASTM D1183-03(2011)
Standard Practices for Resistance of Adhesives to Cyclic Laboratory Aging Conditions
- Standard No.
- ASTM D1183-03(2011)
- Release Date
- 2003
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM D1183-03(2019)
- Latest
- ASTM D1183-03(2019)
- Scope
This practice provides information on the resistance to cyclic laboratory aging.
1.1 These practices cover the determination of the resistance of adhesives to cyclic accelerated service conditions by exposing bonded specimens to conditions of high and low temperatures and high and low relative humidities. The extent of degradation is determined from changes in strength properties as a result of exposure to the test conditions (Note 1). It is recognized that no accelerated procedure for degrading materials correlates perfectly with actual service conditions, and that no single or small group of laboratory test conditions will simulate all actual service conditions. Consequently, care must be exercised in the interpretation and use of data obtained in this practice. The test condition, the number of cycles of the test condition to be used, the particular strength property to be used to determine the extent of degradation, and whether test specimens or test panels are to be used, is specified in the material specification.
Note 18212;These practices/conditions are intended for use with specimens described in the approved ASTM strength test methods for adhesives as follows:
Test Methods D897, D903, D906, D950, D1002, D1062, and Method .
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D1183-03(2011) Referenced Document
- ASTM D1002 Standard Test Method for Apparent Shear Strength of Single-Lap-Joint Adhesively Bonded Metal Specimens by Tension Loading (Metal-to-Metal)
- ASTM D1062 Standard Test Method for Cleavage Strength of Metal-to-Metal Adhesive Bonds
- ASTM D1141 Standard Practice for the Preparation of Substitute Ocean Water
- ASTM D1344 Methods of Testing Cross-Lap Specimens for Tensile Properties of Adhesives
- ASTM D897 Standard Test Method for Tensile Properties of Adhesive Bonds*， 2024-04-19 Update
- ASTM D903 Standard Test Method for Peel or Stripping Strength of Adhesive Bonds
- ASTM D906 Standard Test Method for Strength Properties of Adhesives in Plywood Type Construction in Shear by Tension Loading
- ASTM D907 Standard Terminology of Adhesives
- ASTM D950 Standard Test Method for Impact Strength of Adhesive Bonds
ASTM D1183-03(2011) history
- 2019 ASTM D1183-03(2019) Standard Practices for Resistance of Adhesives to Cyclic Laboratory Aging Conditions
- 2003 ASTM D1183-03(2011) Standard Practices for Resistance of Adhesives to Cyclic Laboratory Aging Conditions
- 2003 ASTM D1183-03 Standard Practices for Resistance of Adhesives to Cyclic Laboratory Aging Conditions
- 1997 ASTM D1183-96e1 Standard Test Methods for Resistance of Adhesives to Cyclic Laboratory Aging Conditions
