ASTM F1290-98a(2011)
Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings
- Standard No.
- ASTM F1290-98a(2011)
- Release Date
- 1998
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM F1290-19
- Latest
- ASTM F1290-19
- Scope
Using the procedures in Sections 8 and 9, the manufacturer''s instructions and equipment, pressure-tight joints can be made between manufacturer-recommended combinations of pipe that are as strong as the pipe itself.
1.1 This practice describes general procedures for making joints with polyolefin pipe and fittings by means of electrofusion joining techniques. These should be regarded as general procedures and not as a substitute for the installation procedures specified by the manufacturers. Manufacturers should be requested to supply specific recommendations for joining their products.
Note 18212;Reference to the manufacturer in this practice is defined as the electrofusion fitting manufacturer.
1.2 The techniques covered are applicable only to joining polyolefin pipe and fittings of related polymer chemistry, for example, polyethylenes to polyethylenes using a polyethylene electrofusion fitting. Consult the manufacturer''s recommendations for compatibility of the electrofusion fitting with the specific pipe or fitting material to be joined.
1.3 The electrofusion joining technique described can produce sound joints between polyolefin pipe and fittings, provided that all products involved (that is, pipe and fittings) meet the appropriate ASTM specifications.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM F1290-98a(2011) Referenced Document
- ASTM D1600 Standard Terminology for Abbreviated Terms Relating to Plastics*， 1999-04-19 Update
- ASTM F1055 Standard Specification for Electrofusion Type Polyethylene Fittings for Outside Diameter Controlled Polyethylene Pipe and Tubing
- ASTM F412 Standard Terminology Relating to Plastic Piping Systems*， 2023-07-20 Update
ASTM F1290-98a(2011) history
- 2019 ASTM F1290-19 Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings
- 1998 ASTM F1290-98a(2011) Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings
- 1998 ASTM F1290-98a(2004) Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings
- 1998 ASTM F1290-98a Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings
