This European Standard specifies tolerances on dimensions and shape for hot-rolled non-alloy and alloy steel plates with the following characteristics:
a) Nominal thickness: 3 mm ≤ t ≤ 400 mm;
b) Nominal width: w ≥ 600 mm.
Tolerances for products of width w < 600 mm cut or slit from plate should be agreed between manufacturer and purchaser at the time of enquiry and order.
This European Standard applies, but is not limited, to steel grades defined in EN 10025-2 to EN 10025-6:2004+A1-2009, EN 10028-2 to EN 10028-6, EN 10083-2 and EN 10083-3, EN 10084, EN 10085,
EN 10149-2 and EN 10149-3, EN 10207 and EN 10225 (see also Annex A). It does not apply to stainless
steels.
This European Standard does not include round plates, custom-made plates, chequer or bulb plate for flooring and wide flats.
BS EN 10029:2010 history
0000 BS EN 10029:2010(2012)
2010BS EN 10029:2010 Hot-rolled steel plates 3 mm thick or above. Tolerances on dimensions and shape
1991BS EN 10029:1991 Specification for tolerances on dimensions, shape and mass for hot rolled steel plates 3 mm thick or above