IEC 60770-2:2010
Transmitters for use in industrial-process control systems - Part 2: Methods for inspection and routine testing

Standard No.

IEC 60770-2:2010

Release Date

2010

Published By

International Electrotechnical Commission (IEC)

Status

Withdraw

Latest

IEC 60770-2:2010

Replace By

IEC 62828-3:2018

Scope

This part of IEC 60770 is applicable to transmitters, which have either a standard analogue electric current output signal or a standard pneumatic output analogue signal in accordance with IEC 60381-1 or IEC 60382. The tests detailed herein may be applied to transmitters which have other output signals, provided that due allowance is made for such differences. For the method of inspection and routine testing of the intelligent transmitters see IEC 60770-3. For certain types of transmitters, where the sensor is an integral part, other specific IEC or ISO standards may need to be consulted (e.g. for chemical analyzers, flow-meters, etc.) This standard is intended to provide technical methods for inspection and routine testing of transmitters, for instance, for acceptance tests or after repair. For a full evaluation, IEC 60770-1 and/or IEC 60770-3, respectively for analogue or intelligent transmitters shall be used. Quantitative criteria for acceptable performance should be established by agreement between manufacturer and user. By agreement the tests need not be carried out by an accredited laboratory.

IEC 60770-2:2010 history

• 2010 IEC 60770-2:2010 Transmitters for use in industrial-process control systems - Part 2: Methods for inspection and routine testing
• 2003 IEC 60770-2:2003 Transmitters for use in industrial-process control systems - Part 2: Methods for inspection and routine testing
• 1989 IEC 60770-2:1989 Transmitters for use in industrial-process control systems; part 2: guidance for inspection and routine testing

IEC 60770-2:2010 Transmitters for use in industrial-process control systems - Part 2: Methods for inspection and routine testing was changed to IEC 62828-3:2018 Conditions de référence et procédures pour l'essai des transmetteurs de mesure industrielle et de processus – Partie 3: Procédures spécifiques pour les transmetteurs de température (Edition 1.0).