ASTM F180-94(2010)e1
Standard Test Method for Density of Fine Wire and Ribbon Wire for Electronic Devices

Standard No.

ASTM F180-94(2010)e1

Release Date

1994

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM F180-94(2015)

Latest

ASTM F180-94(2020)

Scope

1.1 This test method covers the determination of, to an accuracy of 1.0 %, the density of fine wires ranging from 0.25 to 0.02 mm in diameter, or ribbons of similar thicknesses, for electronic devices.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 4.

ASTM F180-94(2010)e1 history

• 2020 ASTM F180-94(2020) Standard Test Method for Density of Fine Wire and Ribbon Wire for Electronic Devices
• 1994 ASTM F180-94(2015) Standard Test Method for Density of Fine Wire and Ribbon Wire for Electronic Devices
• 1994 ASTM F180-94(2010)e1 Standard Test Method for Density of Fine Wire and Ribbon Wire for Electronic Devices
• 2005 ASTM F180-94(2005) Standard Test Method for Density of Fine Wire and Ribbon Wire for Electronic Devices
• 1994 ASTM F180-94(1999) Standard Test Method for Density of Fine Wire and Ribbon Wire for Electronic Devices