ASTM F2737-10a
Standard Specification for Corrugated High Density Polyethylene (HDPE) Water Quality Units

Standard No.

ASTM F2737-10a

Release Date

2010

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM F2737-11

Latest

ASTM F2737-11(2021)

Scope

1.1 This specification covers materials, structural design, physical dimensions and manufacturing requirements for monolithic or sectional corrugated high density polyethylene (HDPE) water quality units with volumes greater than or equal to 140 ft³ or 1,050 gal (4,000 L).

1.2 The corrugated HDPE water quality units are placed as offline or inline treatment devices along storm drain pipe lines to remove total suspended solids (TSS), heavy metals and phosphorous. Typical sources of pollutants include construction activity, automotive transportation related wear and debris items, refuse, landscaping debris, agricultural activities, and other similar by-products.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This specification covers horizontally laid corrugated HDPE water quality units as illustrated in Fig. 1.

1.5 The following safety hazard caveat pertains only to the test methods portion, Section 9, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

HDPE water quality units contain three (3) chambers. A side inlet may be used in lieu of the end inlet and flow diverter when a full height longitudinal partition is constructed in the sediment chamber compartment to extend the particle travel length and isolate incoming flow from sediment build-up.

FIG. 1 Horizontally Laid Corrugated HDPE Water Quality Units

ASTM F2737-10a Referenced Document

• ASTM D1600 Standard Terminology for Abbreviated Terms Relating to Plastics
• ASTM D3212 Standard Specification for Joints for Drain and Sewer Plastic Pipes Using Flexible Elastomeric Seals
• ASTM D3350 Standard Specification for Polyethylene Plastics Pipe and Fittings Materials*， 2024-04-19 Update
• ASTM F2306/F2306M Standard Specification for 300 mm to 1500 mm [12 in. to 60 in.] Annular Corrugated Profile-Wall Polyethylene (PE) Pipe and Fittings for Non-Pressure Gravity-Flow Storm Sewer and Subsurface Drainage Ap
• ASTM F412 Standard Terminology Relating to Plastic Piping Systems
• ASTM F477 Standard Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe
• ASTM F714 Standard Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Outside Diameter

ASTM F2737-10a history

• 2021 ASTM F2737-11(2021) Standard Specification for Corrugated High Density Polyethylene (HDPE) Water Quality Units
• 2011 ASTM F2737-11(2017) Standard Specification for Corrugated High Density Polyethylene (HDPE) Water Quality Units
• 2011 ASTM F2737-11 Standard Specification for Corrugated High Density Polyethylene (HDPE) Water Quality Units
• 2010 ASTM F2737-10a Standard Specification for Corrugated High Density Polyethylene (HDPE) Water Quality Units
• 2010 ASTM F2737-10 Standard Specification for Corrugated High Density Polyethylene (HDPE) Water Quality Units