ISO 286-2:2010
Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
- Standard No.
- ISO 286-2:2010
- Release Date
- 2010
- Published By
- International Organization for Standardization (ISO)
- Status
- Replace By
- ISO 286-2:2010/cor 1:2013
- Latest
- ISO 286-2:2010/cor 1:2013
- Scope
- This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit deviations EI (for holes) and ei (for shafts) (see Figures 1 and 2).
ISO 286-2:2010 Referenced Document
- ISO 286-1:2010 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 1: Basis of tolerances, deviations and fits
ISO 286-2:2010 history
- 2013 ISO 286-2:2010/cor 1:2013 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts; Technical Corrigendum 1
- 2010 ISO 286-2:2010 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
- 2006 ISO 286-2:1988/Cor 1:2006 ISO system of limits and fits - Part 2: Tables of standard tolerance grades and limit deviations for holes and shafts; Technical Corrigendum 1
- 1988 ISO 286-2:1988 ISO system of limits and fits; part 2: tables of standard tolerance grades and limit deviations for holes and shafts
