ASTM D6487-10
Standard Practice for Preparing Prints of Paste Printing Inks Using a Hand Operated Laboratory Flat-Bed Press
- Standard No.
- ASTM D6487-10
- Release Date
- 2010
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM D6487-10(2019)
- Latest
- ASTM D6487-10(2019)
- Scope
Laboratory proofing of ink is necessary to establish a reproducible prediction of print appearance and performance properties, most of which are highly sensitive to ink film thickness. The apparatus described in this practice has found wide use for routine control proofing because it provides an economical method for producing reasonably large prints at film thicknesses comparable to those obtained on production presses.
This practice does not duplicate the dynamics of a high speed press, nevertheless, it is useful for quality control and for specification acceptance between the producer and the user where there is an agreed upon specification for reflection density or standard reference print.
1.1 This practice covers the procedure for preparing prints of paste inks using a hand operated flat-bed laboratory proof press. The initial method was developed by the National Printing Ink Research Institute.
1.3 This practice is applicable primarily to lithographic and letterpress inks that dry by oxidation or penetration. With the addition of appropriate drying or curing equipment, it is also applicable to other systems such as heat-set or energy-curable.
1.4 The instructions in this practice are intended to minimize the within-print and among-operator variability inherent in hand operations.
1.5 This practice does not measure the actual film thickness on the print, but evaluates film thickness equivalence by visual or instrumental comparisons of reflection density.
1.6 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the users of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautions are given in Section 7.
ASTM D6487-10 Referenced Document
- ASTM D6073 Standard Test Method for Relative Setting of Heatset Printing Inks by the Sinvatrol Tester
- ASTM D6846 Standard Practice for Preparing Prints of Paste Printing Inks with a Printing Gage
- ASTM D7305 Standard Test Method for Reflection Density of Printed Matter
ASTM D6487-10 history
- 2019 ASTM D6487-10(2019) Standard Practice for Preparing Prints of Paste Printing Inks Using a Hand Operated Laboratory Flat-Bed Press
- 2010 ASTM D6487-10 Standard Practice for Preparing Prints of Paste Printing Inks Using a Hand Operated Laboratory Flat-Bed Press
- 2004 ASTM D6487-04 Standard Practice for Preparing Prints of Paste Printing Inks by Rollouts on a Laboratory Flat-Bed Press
- 2001 ASTM D6487-01 Standard Practice for Preparing Prints of Paste Printing Inks With an Offset Color Proofing Press
- 1999 ASTM D6487-99e1 Standard Practice for Preparing Prints of Paste Printing Inks With an Offset Color Proofing Press
