For the purpose of determining compliance with the specified limits for requirements of the properties listed in the following table and for dimensional tolerances, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29.
Property | Rounded Unit for Observed or Calculated Value |
Chemical composition | nearest unit in the last right-hand significant digit used in expressing the limiting value |
Hardness | |
Electrical resistivity | |
Electrical conductivity | |
Tensile strength | nearest ksi [5 MPa] |
Yield strength | |
Elongation: | nearest 1 % |
Grain size: | |
Under 0.060 mm | nearest multiple of 0.005 mm |
0.060 mm and over | nearest 0.01 mm |
1.1 This specification establishes the general requirements common to wrought copper and copper alloy rod, bar, shapes, and forgings which shall apply to Specifications B16/B16M, B21/B21M, B98/B98M, B124/B124M, B138/B138M, B139/B139M, B140/B140M, B150/B150M, B151/B151M, B196/B196M, B283, B301/B301M, B371/B371M, B411/B411M, B441, B453/B453M, B455,