ASTM G121-98(2010)e1
Standard Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents
- Standard No.
- ASTM G121-98(2010)e1
- Release Date
- 1998
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM G121-98(2015)e1
- Latest
- ASTM G121-18
- Scope
This practice will be suitable to direct the preparation of test coupons with a known amount of contaminant on the surface. A standard test coupon is described and a list of contaminants that have typically been found in oxygen-enriched systems and components is provided.
These coupons shall be used in the evaluation of cleaning agents for oxygen-enriched systems and components. This will permit direct comparison within and between test facilities.
Materials used in other fluid handling systems such as nitrogen, helium, hydrogen, gasoline, etc. may also be prepared for evaluation by this practice.
1.1 This practice describes the procedure for the preparation of single- and double-sided contaminated metallic test coupons for the evaluation of cleaning agents. It is applicable for the evaluation of cleaning agents proposed for the cleaning of oxygen-enriched systems and components. It also is applicable to other systems where contamination is a concern.
1.2 Several classes of contaminants most likely to be found in oxygen-enriched systems and components are identified. However, if the user of this practice has identified contaminants not included in these classes, such identified contaminants may be substituted for the preparation of the test coupons.
1.3 Preparation of nonmetallic substrates is not addressed, although similar methodology may be used. Solvent and cleaning agent compatibility with the nonmetallic substrate should be verified prior to the preparation of the test coupons. Typical nonmetallic materials utilized in oxygen systems are contained in Guide G63.
1.4 This practice may involve hazardous materials, operations, and equipment. This practice does not purport to address all of the safety concerns associated with its use. It is the responsibility of whomever uses this practice to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM G121-98(2010)e1 Referenced Document
- ASTM D1193 Standard Specification for Reagent Water*， 1999-04-19 Update
- ASTM E1235 Standard Test Method for Gravimetric Determination of Nonvolatile Residue (NVR) in Environmentally Controlled Areas for Spacecraft
- ASTM F303 Standard Practices for Sampling Aerospace Fluids from Components
- ASTM F312 Standard Test Methods for Microscopical Sizing and Counting Particles from Aerospace Fluids on Membrane Filters
- ASTM F324
- ASTM F331 Standard Test Method for Nonvolatile Residue of Solvent Extract from Aerospace Components (Using Flash Evaporator)*， 2020-04-01 Update
- ASTM G63 Standard Guide for Evaluating Nonmetallic Materials for Oxygen Service*， 1999-04-19 Update
- ASTM G94 Standard Guide for Evaluating Metals for Oxygen Service
ASTM G121-98(2010)e1 history
- 2018 ASTM G121-18 Standard Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents
- 1998 ASTM G121-98(2015)e1 Standard Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents
- 1998 ASTM G121-98(2010)e1 Standard Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents
- 1998 ASTM G121-98(2004) Standard Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents
- 1998 ASTM G121-98 Standard Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents
