ISO 16110-2:2010
Hydrogen generators using fuel processing technologies - Part 2: Test methods for performance

Standard No.

ISO 16110-2:2010

Release Date

2010

Published By

International Organization for Standardization (ISO)

Latest

ISO 16110-2:2010

Scope

This part of ISO 16110 provides test procedures for determining the performance of packaged, self-contained or factory matched hydrogen generation systems with a capacity less than 400 m3/h at 0 °C and 101,325 kPa, herein referred to as hydrogen generators, that convert a fuel to a hydrogen-rich stream of composition and conditions suitable for the type of device using the hydrogen (e.g. a fuel cell power system, or a hydrogen compression, storage and delivery system).

ISO 16110-2:2010 Referenced Document

• IEC 61010-1 Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 1: General requirements*， 2017-01-01 Update
• IEC 61672-1 Electroacoustics - Sound level meters - Part 1: Specifications*， 2013-09-01 Update
• ISO 10101 Natural gas — Determination of water by the Karl Fischer method — Part 3: Coulometric procedure*， 2022-08-31 Update
• ISO 10523 Water quality - Determination of pH
• ISO 10707 Water quality - Evaluation in an aqueous medium of the "ultimate" aerobic biodegradability of organic compounds - Method by analysis of biochemical oxygen demand (closed bottle test)
• ISO 11042 Gas turbines - Exhaust gas emission - Part 2: Automated emission monitoring
• ISO 11541 Natural gas - Determination of water content at high pressure
• ISO 11564 Stationary source emissions - Determination of the mass concentration of nitrogen oxides - Naphthylethylenediamine photometric method; Technical Corrigendum 1
• ISO 14687-1 Hydrogen fuel — Product specification — Part 1: All applications except proton exchange membrane (PEM) fuel cell for road vehicles — Technical Corrigendum 2
• ISO 14687-2 Hydrogen fuel - Product specification - Part 2: Proton exchange membrane (PEM) fuel cell applications for road vehicles*， 2012-12-01 Update
• ISO 16622 Meteorology - Sonic anemometers/thermometers - Acceptance test methods for mean wind measurements
• ISO 3744 Acoustics - Determination of sound power levels and sound energy levels of noise sources using sound pressure - Engineering methods for an essentially free field over a reflecting plane*， 2010-10-01 Update
• ISO 4677 Atmospheres for conditioning and testing; Determination of relative humidity; Part 2 : Whirling psychrometer method
• ISO 5167 Measurement of fluid flow by means of orifice plates, nozzles and Venturi tubes inserted in circular cross-section conduits running full
• ISO 6060 Water quality; determination of the chemical oxygen demand
• ISO 6326 Natural gas; determination of sulfur compounds; part 5: Lingener combustion method
• ISO 6974 Natural gas; Determination of hydrogen, inert gases and hydrocarbons up to C8; Gas chromatographic method
• ISO 6975 Natural gas - Extended analysis - Gas-chromatographic method
• ISO 7934 Stationary source emissions — Determination of the mass concentration of sulfur dioxide — Hydrogen peroxide/barium perchlorate/Thorin method AMENDMENT 1
• ISO 9096 Stationary source emissions — Manual determination of mass concentration of particulate matter*， 2017-08-21 Update

ISO 16110-2:2010 history

• 2010 ISO 16110-2:2010 Hydrogen generators using fuel processing technologies - Part 2: Test methods for performance