DIN EN 60947-7-1:2010
Low-voltage switchgear and controlgear - Part 7-1: Ancillary equipment - Terminal blocks for copper conductors (IEC 60947-7-1:2009); German version EN 60947-7-1:2009

Standard No.

DIN EN 60947-7-1:2010

Release Date

2010

Published By

German Institute for Standardization

Latest

DIN EN 60947-7-1:2010

Replace

DIN EN 60947-7-1/A1:2007 DIN EN 60947-7-1:2003

Scope

This part of IEC 60947 specifies requirements for terminal blocks with screw-type or screwless-type clamping units primarily intended for industrial or similar use and to be fixed to a support to provide electrical and mechanical connection between copper conductors. lt applies to terminal blocks intended to connect round copper conductors, with or without special preparation, having a cross-section between 0, 2 mm2 and 300 mm2 (AWG 24/600 kcmil), intended to be used in circuits of a rated voltage not exceeding 1000 V a.c. up to 1000 Hz or 1500 V d.c.

DIN EN 60947-7-1:2010 Referenced Document

• ISO 4046-4:2002 Paper, board, pulps and related terms - Vocabulary - Part 4: Paper and board grades and converted products

DIN EN 60947-7-1:2010 history

• 2010 DIN EN 60947-7-1:2010 Low-voltage switchgear and controlgear - Part 7-1: Ancillary equipment - Terminal blocks for copper conductors (IEC 60947-7-1:2009); German version EN 60947-7-1:2009
• 0000 DIN EN 60947-7-1/A1:2007
• 0000 DIN EN 60947-7-1:2003