EN 15657-1:2009
Acoustic properties of building elements and of buildings - Laboratory measurement of airborne and structure borne sound from building equipment - Part 1: Simplified cases where the equipment mobilities are much higher than the receiver mobilities, taking

Standard No.
EN 15657-1:2009
Release Date
2009
Published By
European Committee for Standardization (CEN)
Latest
EN 15657-1:2009
Scope
Part 1 of this European Standard shall apply to any source-receiver configuration where the receiver mobility is 10 dB below the source mobility (see definition of mobility in Clause 3 below). However, part 1 is restricted for the moment to whirlpool baths since onlyThis type of building equipment has been experimentally studied so far; for other types of building equipment, the principle of the method is still valid, but some details in the standard might not be relevant. Therefore,This first part: specifies methods for the measurement under laboratory conditions of airborne and structure borne sound produced by whirlpool baths connected to low mobility structures; for the case of whirlpool baths, building structures of mass per unit area equal or greater than 220 kg/m2, hollow elements excluded, are considered as low mobility elements; defines the expression of the results, including data for comparison between products (single value descriptors) and input data for the prediction method (link to EN 12354-5 explained in Annex B).

EN 15657-1:2009 history

  • 2009 EN 15657-1:2009 Acoustic properties of building elements and of buildings - Laboratory measurement of airborne and structure borne sound from building equipment - Part 1: Simplified cases where the equipment mobilities are much higher than the receiver mobilities, taking



Copyright ©2024 All Rights Reserved